HOW TO: Install the YakAttack slider

HOW TO: Install the YakAttack slider

April 18, 2020

INSTALLING THE YAKATTACK SLIDER ONTO YOUR PADDLE BOARD USING THE SEAMOUNT® SYSTEM

FROM THE PAU HANA SUP SCHOOL

Kit Contains:

1 YakAttack Slider

2 Screws

Step 1: Lightly Spray screws with lubricating oil, like WD-40 on first use and a couple times a season after that.

Step 2: Line up the the YakAttack Slider over two SeaMounts® that are 10”-12” apart on the paddle board.

Step 3: Use a phillips head screwdriver to screw the screws into the SeaMounts®.

Step 4: Remove the YakAttack Slider when traveling and transporting your SUP board.

Step 5: Rinse paddle board and accessories with freshwater if used in saltwater.

To purchase the YakAttack Slider CLICK HERE.

 



Also in How To's

HOW TO: Set up the Calypso stand-up kayak
HOW TO: Set up the Calypso stand-up kayak

June 02, 2022

Learn how to install the window, fins and seat in this instructional video.

Read More

HOW TO KEEP YOUR PADDLEBOARD STRAIGHT
HOW TO KEEP YOUR PADDLEBOARD STRAIGHT

October 22, 2021

Learn how to keep your paddleboard tracking in a straight line with tips from the Pau Hana SUP School.

Read More

HOW TO: Adjust the Aluminum SUP Paddle
HOW TO: Adjust the Aluminum SUP Paddle

April 16, 2021

An instructional guide on tightening the shaft clamp and adjusting the Aluminum SUP Paddle.

Read More