HOW TO: Install the YakAttack Roto Grip Paddle Holder

HOW TO: Install the YakAttack Roto Grip Paddle Holder

May 06, 2020

Installing the YakAttack Roto Grip Paddle Holder onto your paddle board using the SeaMount® system.

From the pau hana sup school

 

Kit Contains:

2 YakAttack Roto Grip Paddle Holders (Two works better than one)

Step 1: Lightly Spray screws with lubricating oil, like WD-40 on first use and a couple times a season after that.

Step 2: Hand screw the YakAttack Roto Grips into the SeaMounts® that are on the side of the paddle board. Do not overtighten.

Step 3: Remove the YakAttack Roto Grips when traveling and transporting your SUP board.

Step 4: Rinse your paddle board and accessories with freshwater if used in saltwater to avoid rusting.

To purchase the YakAttack Roto Grip Paddle Holders CLICK HERE.




Also in How To's

HOW TO: Set up the Calypso stand-up kayak
HOW TO: Set up the Calypso stand-up kayak

June 02, 2022

Learn how to install the window, fins and seat in this instructional video.

Read More

HOW TO KEEP YOUR PADDLEBOARD STRAIGHT
HOW TO KEEP YOUR PADDLEBOARD STRAIGHT

October 22, 2021

Learn how to keep your paddleboard tracking in a straight line with tips from the Pau Hana SUP School.

Read More

HOW TO: Adjust the Aluminum SUP Paddle
HOW TO: Adjust the Aluminum SUP Paddle

April 16, 2021

An instructional guide on tightening the shaft clamp and adjusting the Aluminum SUP Paddle.

Read More