Menu 0
HOW TO: Install D-rings with Bungee

HOW TO: Install D-rings with Bungee

GEAR HOW TO PRO TIPS VIDEO

April 20, 2020

Installing the PAu Hana D-rings with bungee into the SeaMount®s on your paddle board

From the Pau Hana SUP School

 

Kit Contains:

4 D-Rings

4 Screws

1 Bungee Cord

Step 1: Lightly Spray each screw with lubricating oil, like WD-40 on first use and a couple times a season after that.

Step 2: Place each D-Ring over a SeaMount® and use a phillips head screwdriver to screw the D-Rings into place. Do not overtighten screws. The four SeaMounts® on the front of the paddle board are the preferred location for placement for most paddlers.

Step 3: Run the bungee cord through the 4 D-Rings in an “X” pattern.

Step 4: Pull the ends tight and secure with an overhand knot.

Step 5: Rinse paddle board and accessories with freshwater after use in saltwater to avoid rusting.

To purchase the Pau Hana D-rings and bunee CLICK HERE.



Also in How To's

HOW TO: Set up the Calypso stand-up kayak
HOW TO VIDEO
HOW TO: Set up the Calypso stand-up kayak

June 02, 2022

Learn how to install the window, fins and seat in this instructional video.

Read More

HOW TO KEEP YOUR PADDLEBOARD STRAIGHT
HOW TO PRO TIPS
HOW TO KEEP YOUR PADDLEBOARD STRAIGHT

October 22, 2021

Learn how to keep your paddleboard tracking in a straight line with tips from the Pau Hana SUP School.

Read More

HOW TO: Adjust the Aluminum SUP Paddle
HOW TO PRO TIPS
HOW TO: Adjust the Aluminum SUP Paddle

April 16, 2021

An instructional guide on tightening the shaft clamp and adjusting the Aluminum SUP Paddle.

Read More