Step 1: Put the square washer onto the end of the screw
Step 2: Hold the screw and lower the washer into the track
Step 3: Slide the washer forward
Step 4: Lower the dowel into the track and slide it back
Step 5: Lower the front of the fin and line up the hole in the top to the hole in the washer
Step 6: Drop the screw in through the hole and tighten into the washer
Step 7: Tighten only a turn and an half to two times after making contact with the bottom
Tip: When ever the fin is removed from the board, always put the screw and washer back into the track so it doesn't get lost.
Comments will be approved before showing up.